loading spectrum造句
例句与造句
- A sharc - based data acquisition and analysis system for load spectrum
的载荷谱数据采集与分析系统 - Sdudy on annealing character of fatigue life gage and load spectrum calculation by its electrical resistance change response
疲劳寿命计退火特性及电阻变化推算载荷谱的研究 - The test must work in a specify rotation spectrum , temperature spectrum and load spectrum to analogize the reality condition
实验器要在一定的载荷谱、温度谱、转速谱条件下工作,模拟轴承的实际工况。 - Based on axle load spectrum , a method to calculate the maximum design load of asphalt pavements was first studied according to reliability theory
并根据轴载谱,提出了按可靠度理论计算沥青路面最大设计荷载的方法。 - Based on the experiment investigation , the law varying with wind directions of three dimensional wind load spectrum and its mechanism are analyzed , and some conclusions are obtained
得到三维风荷载谱随风向角的变化规律及其产生机理，进而做出了若干结论。 - It's difficult to find loading spectrum in a sentence. 用loading spectrum造句挺难的
- The long - term life and low cycle fatigue life of low pressure turbine blade for an aeroengine under real loading spectrum is analyzed by using this method
用该方法对某型发动机低压涡轮工作叶片在实际飞行载荷谱作用下的持久寿命和低循环疲劳寿命进行了分析。 - In chapter 2 , the fatigue mechanism of automobile half shaft is studied ; and intensified coefficient model based on fatigue failure theory and programmed load spectrum technology is also provided
第二章研究汽车驱动桥半轴疲劳破坏机理，在零件疲劳损伤理论和程序载荷谱处理技术基础之上给出路面强化系数模型。 - In the simulator test , the artic1e gives the method for superposition of two different phrase and unrelated load spectrums and the method can be used to solve the same question latter
在模拟试验件试验中，文章采用工程方法对两种不同相位、不相关的载荷谱迭加问题进行了处理，这对今后碰到此类问题有一定的借鉴作用。 - The result of study shows that there are rather big effects on the statistics of load spectrum of gear by considering the load distribution among gear teeth , and lowered the result of prediction on bending fatigue life of gear
研究结果表明，考虑齿间载荷分布对齿轮载荷谱的统计特征有较大影响，并降低了齿轮的弯曲疲劳寿命预测结果。 - The tested results showed that the collecting ring could be used for the dynamic stress test successfully and the experimental data would be used for determining load spectrum and analyzing fatigue life of spoke plate
结果表明，动态测试过程稳定，所设计和制造的集流环完全满足试验要求，测试数据可以用于结构载荷谱的编制和疲劳寿命分析。 - The test for simulating load spectrum of bridge was done , comparison of the infered load spectrum by means of the electrical resistance changes of two fatigue life gage with the simulated load spectrum showed reasonably good agreement
进行了模拟桥梁荷载谱加载试验,用双疲劳寿命计电阻变化所推算荷载谱和模拟荷载谱基本一致,证明了方法的可行性。 - According to the characteristics of the load on the canopy , the method for measuring the load on the canopy with a pressure sensor is presented , and then the flight measurement of the load spectrum of the canopy is realized for the first time
根据实测活动舱盖载荷曲线特点,提出了任务类型划分方法,建立了活动舱盖载荷谱数据统计方法和载荷谱编制方法,并依此编制出k8飞机活动舱盖载荷谱。 - Based on the speciality of load spectrum of bridge , a new method to infer load spectrum of bridge with two fatigue life gage installed on the same strain multiplier was proposed , substantive progress in the fatigue damage calculation applied to the bridge with fatigue life gage
针对桥梁荷载谱特性,提出基于同一倍增器上双疲劳寿命计的桥梁荷载谱推测方法,为基于疲劳寿命计的桥梁疲劳损伤计算,迈出了关键一步。 - On the basis of a reliable finite element model , the load spectrum as specified in aar standard and the s - n curve database for welding joints , regarding the new type of heavy haul open top wagon as the analysis object , fatigue life prediction is conducted in the design phase
基于可靠的有限元数值仿真模型，以及美国aar标准中的载荷谱、焊接接头的s - n曲线数据库，以重载新型敞车为应用对象，在设计阶段对其进行了疲劳寿命预测，预测结果表明该车确实存在疲劳寿命薄弱部位。 - Before the development of the system , the article describes the above - mentioned aspects , as the bases of the system development . the article emphasizes related auto - controlling technologies : open - 100p and close - 100p , and control mode of negative - feedback , the scatter and quantization of the simulate signal , the conception of a / d and d / a conversion and code / encode , the basic sampling principles of the simulate signal . the article introduces the operation method and process of the system by means of the load spectrum
文章对相关的理论进行了陈述，以作为系统开发的理论依据，重点阐述了自动控制系统中包括开环闭环在内的几大主要控制模式，以及有关的负反馈控制方式，模拟信号的离散与量化，模数转换、数模转换、编码译码的概念，及模拟信号采样的基本原理? ?采样定理，并以载荷谱法为例，简述了所研究的系统将要采取的工作方式及工作过程。
更多例句： 下一页